Headlamp Dust Cover

i made a set of covers for headlight bulbs for a 2007 pontiac g6, they come with them factory an seal the headlight so dust and moisture stays out but when buying led lights they require u to cut a hole in the dust cover to make room for the heat sink on the buld so instead of cutting up the new headlights covers i designed first a set that was almost identical just a little taller with clearance for the buld but the wiring got in the way so i made one that was really big to give plenty of room for cooling an the wiring but that interfered with the frame of the car so i ended up making quite a few til i found the right fit for each bulb cause each builb sit at a different height an each cover had a different distance between the frame an the healight so im putting them all up so anyone can use them if needed or if they look like they will fit what u need. there is a test piece that u can print that will make sure it fits an locks into ur headlights only thing u have to do is take the old rubber seals from the factory caps an put on the test print to make sure it fits then move the seal to each of the covers as u need them, even if ur lights have a fan for cooling instead of cutting up the factory part just print these out an cut them, i should have made one with the opening so i may end up adding that in the future if anyone requests. i hope someone can get some use out of them.

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed