Panel

I wanted replace the original panel of my Dacia Duster 2108 with a one with more connection. The panel is flat so it is simple to draw, I added another cig-plug, a double USB with voltmeter, an XT60 for high current use, a light for the tunnel with his switch. The panel can be printed in normal pla for semplicity but if you leave your car under the sun for many hours there is the risk of deformation. I have not tested to print it with ABS but I presume is a good idea. I used instead a High Temperature PLA from Paperdifferent. In this way, after the print, the material can be hardened keeping it for 90 minutes at 90°. After this it can support over 100° with no deformations.
ATTENTION: If you use HT PLA you must scale the models to 101.25 because during the hardening process the material become a little narrow (for my HTPLA I used 101.25, the seller suggested 102 but was too much). There are same STL files, original panel, original panel with screw fixing (2 screws can be used from car), panel with not proper fits and with accessories Iused (from wish.com).
NOTE: the Musk.stl is for have the idea of the profile hole of the inner of the panel to puts accessories in the right spaces avaliable.
ADDITIONAL DXF FILE: I added a dxf file that you can convert for CNC machine if you want use a Flat panel of aluminium or plastic materials.

10/10/2018 Added new photo of the realizazion with a 3mm carbon sheet.

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed